PLUGSYS R-Wave Trigger Module (RWT)
Triggers (starts) a stimulator or any other device with the R-wave of an ECG signal. Requires ECGA module.
The R-Wave Trigger Module (RWT) is especially designed to trigger (start) a stimulator or any other device with the R-wave of an ECG signal.
The ECG signal is measured with the PLUGSYS ECG Amplifier Module (ECGA) . The R-wave trigger module is internally connected to the ECG Amplifier and works only together with this amplifier.
The R-wave trigger module can be used (e.g., for synchronized stimulation of the heart) by triggering a delay module of a stimulator. It is possible to set the stimulation pulses delayed from the R-wave into the vulnerable phase to produce ventricular fibrillations. The trigger output of this module must be connected to the trigger input of a stimulator with a BNC cable.
| Specifications | 73-1753 |
|---|---|
| Accessories | BNC output cable, operating instructions |
| Adjustable Blocking Time | Blocking time for trigger signal can be adjusted so that circuit is inactive for fixed time; time can be set with potentiometer 'BLOCKING TIME' in range from 50 msec to 500 msec; LED indicates blocking time |
| Dimensions (H x W x D) | 5.1 x 0.8 x 3.9 in (128.7 x 20.2 x 100 mm) |
| Output | BNC connector TRIGGER OUT at front panel open collector TTL signal, pull-up resistor 2.2 k; jumper on board defines whether positive or negative pulses used as trigger pulses |
| PLUGSYS Width* | 1 slot unit |
| Power Supply | Through ECG Amplifier Type 689 |
| R-Wave Indication | LED and beep to indicate R-wave; loudness of beep can be set with potentiometer |
| Threshold | Threshold for triggering can be set with potentiometer |
| Weight | 0.4 lb (0.2 kg) |
| Accessories | BNC output cable, operating instructions |
