PLUGSYS Trigger Input/Output Module (ROM-T)
For triggering (starting) external equipment, e.g. stimulators, oscilloscopes, ventilators. Synchronizes HA-HSE Data Acquisition Software with external equipment.
The PLUGSYS Trigger Input/Output Module(ROM-T) is used as a trigger input and output. It provides two trigger inputs and two trigger outputs to the PLUGSYS system.
BNC sockets 1 and 2 are used as trigger outputs, the BNC sockets 3 and 4 are used as trigger inputs. This module is connected to the module ROM-A and mounted in the PLUGSYS Mainframe from the rear. With the trigger outputs 1 and 2 it is possible to trigger an oscilloscope from a PLUGSYS module providing this feature. With the trigger inputs 3 and 4 it is possible to trigger a PLUGSYS module from the outside, e.g. triggering a module with an external stimulator.
|Accessories||2 BNC-BNC output cables|
|Dimensions (H x W x D) English||5.1 x 0.8 x 4.3 in|
|Dimensions (H x W x D) Metric||128.7 x 20.2 x 100 mm|
|Input||2 inputs, TTL or CMOS-signal dynamic inputs, acting on falling edge|
|Output||2 TTL outputs, open collector TTL signal, low activ. pull-up resistor 2.2 k?|
|PLUGSYS Width*||1 slot unit|
|Weight (English)||5.3 oz|
|Weight (Metric)||150 g|