Platform Interface Cables, Thermistors and Replacement Parts
Interface cables and thermisitors for connecting Warner temperature controllers to Warner products.
|
CC-28 - Interface cable with DIN connector for TC-324B and TC-344B and thermisitors. The CC-28 cable assembly has two thermistors at the platform end; the control thermistor (T1) which attaches to the platform and a bead thermistor (T2) for monitoring the bath temperature. The CC-28 is primarily used to connect any Series 20 heater platform to either a TC-324B or TC-344B temperature controller. The CC-28 will also connect several other chambers, including the DH-35 and DH-35i Cell Culture Dish Incubator/Heater for 35 mm dishes, the QE-1 Quick Exchange Platform, and the DH-40i Cell Culture Dish Incubator/Heater for RC-40 chambers. |
 |
| CC-15 - Interface cable with tinned leads (no DIN connector) and thermisitors |  |
| CC-35 - Interface cable with DIN connector for TC-324B and TC-344B, no thermisitors |  |
| TA-29 - Cable with bead thermisitor, BNC end, included with most inline solution heaters, and can be replaced by TS-70B |  |
| TA-30 - Cable with glass bead thermisitor, BNC end, and can be replaced by TS-30G |  |
| TS-60P - Replacement probe thermisitor for CC-28 cable |  |
| TS-70B - Replacement bead thermisitor for CC-28 cable |  |
|
RH-2 - Heater blocks for Series P and Series PM platforms. Non-heater platforms can be converted to heater platforms with an upgrade kit consisting of a pair of resistive heater blocks, heat transfer pads and mounting screws. Tapped holes for the heater blocks are included in all plain platforms. The only tool required for installation is a small Philips screwdriver. The kit is ordered with either the CC-28 or CC-15 cable assembly. Note: Older platform models may not be upgradeable. Consult Warner Technical Support if your platform does not have slots under the 'wings'. |
 |
| Specifications |
|---|