Model PI-1 Power Interface
The PI-1 Power Interface Module will allow a single syringe warmer to run from a 12 volt battery or power supply. Voltage outputs at 100 mV/°C are provided to monitor both the set and actual temperatures. The power is fuse...
more
Model PS-560 Syringe Heater Stand
The syringe heater stand will accommodate up to eight syringe heaters. The stand has a large base for stability. Mounting rods are thermally non-conducting plastic. The 90 cm long vertical rod permits a wide range of height...
more
Model SW-10/6 Six 10 cc Syringe Heater
Solution reservoir heating is an important technique used to eliminate outgassing of solutions in a heated perfusion chamber. Since the gas load of a solution has dependence on pressure and temperature, preheating a solution at...
more
Model SW-60 Syringe Heater for 60 cc Syringe
Solution reservoir heating is an important technique used to eliminate outgassing of solutions in a heated perfusion chamber. Since the gas load of a solution is dependent on partial pressure and temperature, preheating the...
more
Model SW-61 60 cc Syringe Heater
Solution reservoir heating is an important technique used to eliminate outgassing of solutions in a heated perfusion chamber. Since the gas load of a solution has dependence on pressure and temperature, preheating a solution at...
more
Model SW-707 Power Controller
As many as six SW-60’s can be controlled with the model SW-707 Power Controller. When used in the local mode, the SW-707 allows the temperature of each syringe block to be independently set. A master mode allows all syringe...
more
Model PI-1 Power Interface
Model PS-560 Syringe Heater Stand
Model SW-10/6 Six 10 cc Syringe Heater
Model SW-60 Syringe Heater for 60 cc Syringe
Model SW-61 60 cc Syringe Heater
Model SW-707 Power Controller
