Thermal Insert (TB-3 CS)
The Warner TB-3 CS Thermal Insert is a versatile platform for cell/tissue culture work on the NanoScanZ stage from Prior Scientific.
- Designed for use with Prior Scientific NZ200CE NanoScanZ Piezo Z stage
- Optimized for rectangular chambered slides and chambered coverglass
- Can accept up to 1 x 3' slides
- Temperature control from 5° to 50°C
- Magnetic stainless steel allows use of magnetic holders
- Additional stage adapters available
The TB-3CS is designed to accommodate rectangular chambered slides and coverglass from several manufactures. Slides up to 1x3" can be used.
Precise temperature control of the media is possible when used with our low noise CL-100 or CL-200A temperature controller and heat exchanger (LCS-1, Liquid Cooling System). An integral water jacket is used to remove excess heat from the internal Peltier device. Running water either from a tap or from Warner's LCS-1 may be used.
Magnetic clamps hold slides and chambered coverglasses securely in place. Magnetic stainless steel along the perimeter of the platform allow the use of magnetic tools. It is supplied with two 'L' shaped chambered slide holding brackets, two chambered slide hold-down clamps, one TA- 29 bead thermistor, one MAG-3 magnetic holder for wires, four M- 2 x 10 mm mounting screws for the Prior stage, 20 feet of 1/8' ID x 1/4' OD soft tubing, an allen wrench, and lift tool.
Optional magnetic holders for perfusion and suction tubes allow perfusion in the wells. Stage adapters are available for several major microscopes in addition to the NanoScanZ stage.
|Temperature Range||5° to 50°C|
|Feedback Thermistor||Built in Unical 10kΩ at 25°C|
|Controller||CL-100 Bipolar Controller|
|Aperture Size (D x L)||21.5 x 52.3 mm|
|Thermal Insert Size(D x L x H)||64.0 x 92.2 x 10.5 mm|
|Cable Length||2.4 m|
|Connector Type||15 pin Male 'D'|
|Water Jacket Ports||1/8' Barb Fittings|