Syringe Heater (SW-61)
Solution reservoir heating is an important technique used to eliminate outgassing of perfusate solutions.
- Compatible with TC-324C and TC-344C Heater Controllers
- Quiet operation
- Compact design accommodates a single 60 cc syringe
- Designed for situations where a large heated water bath is inconvenient (such as a shared facility)
Solution reservoir heating is an important technique used to eliminate outgassing of perfustae solutions prior to their entry to a heated perfusion chamber. Since the gas load of a solution has dependence on pressure and temperature, preheating a solution at the final pressure before delivery to the chamber will minimize the occurrence of bubbles in the chamber's bath, even if the solution is allowed to cool en route.
Solution reservoir heaters from Warner Instruments are designed for applications where the use of a large heated water bath is inconvenient, such as a shared facility. Designed to accommodate one 60cc syringe, the SW-61 Heater housing is made of anodized aluminum which is both corrosion resistant and serves as an excellent conductor. Solutions will reach set temperature approximately 15 minutes after application of power.
These heaters may be mounted on any 3/8 or 1/2 diameter lab rod and each unit is supplied with a cable assembly for connection to Warner's TC-324C or TC-344C heater controllers (purchased separately). A TA-29 thermistor is supplied for monitoring the temperature within the syringe. A 60cc syringe is not supplied with this product. Syringes may be ordered separately. The syringe warmer will fit a BD size syringe. Additional useful accessories are also available.
|Syringe Size||60 cc|
|Voltage Requirement||Variable to 12 V Max.|
|Temperature Range||ambient to 65°C (limited by temperature controller)|
|Temperature Accuracy||± 1°C|
|Body, H x W x D||14.8 x 8.1 x 6.4 cm|
|Cable Length||1.9 m|