Recording Output Standard Set
Central output for all selected output signals of the modules in a PLUGSYS Main Frame
• Central output for all selected output signals of the modules in a PLUGSYS Main Frame • Reduces the number of connecting wires • Allows clear connection to any chart recorder or data acquisition system using custom cable The Recording Output Standard Set consists of the ROM-A Type 670/1, ROM-C Type 670/ 7 and BNC Connection Block Type 670/6. This module combination is ideal for connecting a chart recorder or digital data acquisition unit to the PLUGSYS measuring system. The adjustable amplifier module ROM-A buffers all 16 internal analog lines AV1 to AV16. The ROM-A is internally connected to the central output connector module ROM-C and has to be installed into the PLUGSYS rack from the front. The output connector ROM-C can be installed either in the front or at the rear if there is not sufficient module space on the front. ROM-A is an attenuator for the internal analogue lines AV1 to AV16. Each channel individually adjustable from 0 to ±10 Volt for optimum matching with the recording unit. ROM-C is a central output connector 36 pin ribbon type. All outputs have EMI filters to reduce the electromagnetic interference from and to the PLUGSYS measuring system. BNC Connector Block external box with 17 BNC sockets for the 16 analogue lines AV1 to AV16 with additional EMI filters and ESD protection circuit. The maximal cable length between the PLUGSYS and the BNC connector block is nominal 3 m. As a further combination it is possible to use the slave output of the BNC connector block to connect up an additional evaluation and recording unit. If the connected system chart recorder or data acquisition system can handle the output voltages of ±10 Volt, adjustment for each channel individually from 0 to ±10 Volt is not required. In this case the ROM-DL can be substituted for the ROM-A module, and the ROM-C with the BNC connector box can be connected to the ROM-DL and installed either in the front or at the rear of the PLUGSYS system case if there is not sufficient module space on the front.
|PLUGSYS Width*||Operating instructions, 5 BNC cables, connecting cable ROM-A to ROM-C (ribbon), connecting cable ROM-C to BNC connector block are included||Fixing screws, operating instructions, connecting cable ROM-C to ROM-A or DL||2 slot units|