PLUGSYS Case Type 601
Case Type 601 has 10 slot units for PLUGSYS modules.
Note: 601 Case is shown here with four of the TAM-A modules (73-0065) and one ECGA module (73-0149).
The basic system cases with internal system bus are supplied completely wired and ready for use. The Type 601 cases provides a total space of 10 positions (slot units) to accept PLUGSYS modules. An additional power supply (73-3103) is also available. The width of the actual PLUGSYS modules equals either one or a multiple of slot units. For instance, the width of the CFBA Bridge Amplifier is equal to two slot units, therefore it would occupy 2 slot spaces in the PLUGSYS case. The maximum number of PLUGSYS modules — such as a Bridge Amplifier, Differentiator, Integrator, or Heart Rate Module — which can be plugged into a unit system case depends on the number of slot units required by each module.
|Accessories||Line Cable, Screw driver for fitting Function Modules, Document Folder for Operating Instructions of Function Modules, 3 x BNC-BNC Output lines|
|Dimensions (H x W x D) English||5.9 x 9.25 x 16.5 in|
|Dimensions (H x W x D) Metric||150 x 235 x 420 mm|
|Housing Construction||Metallic housing, gray plastic coated with pivoting feet|
|Module Positions||10 slot units max.|
|Power Supply||85 to 264 VAC (40 Watts), output voltage +5 VDC (5 A) and|
|Socket Combination||3-pin IEC mains with fuse and mains switch on back of housing|
|Weight (English)||10.6 lbs without PLUGSYS modules|
|Weight (Metric)||4.8 kg without PLUGSYS modules|