designed for different operating environments and varying degrees of operational flexibility. with selectable target volume or time values to control the total infusion volume. The Infusion Only models do not include programmable, user-defined Methods. defined flow rates and with selectable target volume or time. This model also allows users to create and store up to two user-defined Methods of 50 steps each on the pump. including syringe heaters, in-line heaters and coolers, nanofluidic circuits, connectors, tubing, syringes and more. parameters for infusing or withdrawing liquids through a Method. This may be a Quick Start Method, Pre-Programmed or User-Defined Method. The basic operation is a simple 3-step procedure: 2. Enter operating parameters 3. Preview or Run your method combination (depending upon the model). Custom user-defined Methods can be created when more advanced programming is required. The setup for a custom Method is easy using the standard profiles found on all Infusion/Withdrawal Programmable Elite Models. The list of available profiles is: multi-user errors are reduced. Easily transfer Methods to other pumps and/or download Methods from a PC. Forget having to duplicate Method-development efforts for each new pump added to your system. · Near End of Run · Power Up · Stall · Alphanumeric keypad for method naming Depending upon the syringes you are working with and your overall experimental setup you may want to adjust the amount of force applied to the pusher block. You can select a percentage of the total force from 20% to 100%. Refer to the user's manual for suggested force level settings. |